While the Orky claws are probably going to be my official hand I wanted to try a new type of paw
this paw 14 brass hinges with 2 pieces if scrap wood. Now this build is 15 separate wooden parts each finger section is 2 and 1/2 inches long and the finger tips have been whittled down
We added the brass eyelets. thats 57 screw in brass eyelets.... my fingers were sore after that. 5 packets of them from the dollar tree from a picture hanging packet. Thats 3 for each finger section 2 on top, and 1 in the middle on the bottom, but only 2 on each finger tip. you'll also need a row across the top of the knuckles and on the palm you'll use them as guides. I then ran clear plastic tubing through the eyelets I put on the palm and hot glued it into place. I used the same springs from my Ork claws cut down to fit the new hands stretched between the eyelets on the back of the hands, this will pull the fingers back into place, I used heavy duty fishing line. I tied off one end of the line to the finger tip eyelet and threaded it through the eyelets on the bottom of the fingers, and threaded it through the corresponding control tube.
I then made a control glove. It's nothing special just an old leather glove with the fingertips cut off and split ring key ring loops sewn to the ends.