So yeah, my brother was kind enough to get hold of a few transmission gears for my plastic reclaimer, and I decided to clean them up and take some measurements so I could start designing the housing, supports, and gears needed to make it work. The design is simple, and will use manual power until I can find a drive motor strong enough for the task. All said and done, this should reduce even solid prints to a crumbled mass, which will be fed to a set of shred blades down underneath. The blades, unfortunately, will only cut the plastic into 1/8" strips, but the feed augur at the bottom should cut the strips into roughly quarter inch sized pieces, which can then mixed with unprocessed pellets, and extruded into new, useable filament. The hard part is going to be making the extruder, but I like a challenge. Progress updates will come to this as work is done.
Details
Published:
7 years, 6 months ago
24 Oct 2016 15:55 CEST
Initial: f1f5a75a79d66df8b154250369439203
Full Size: b932f52a077d97bfad64f7ef3e41e67c
Large: 54422a73208494f0451133ca5d123553
Small: 906d848c4d3d7e054b7de138a6bf2a06
Stats
34 views
0 favorites
0 comments
